Can you nail into hardiplank

Clusters, steps, and zippers are all common patterns that can ruin the look of larger walls. With the rising popularity of architectural panels in Edmonton, designers and contractors are often choosing Hardie Panel with Easy Trim as a modern design option that saves homeowners money check out our blog post on contemporary design to learn more about Hardie Panel and Easy Trim.

Hardie Panels weigh 2. James Hardie has tested and approved many nail and screw patterns for their panels, just make sure that your contractor knows them.

Hardie Plank siding is almost always installed with air nailers, which are the best tool for quick installation.

The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly, and will lose track of where the nails are going. Any lower and you might see a few nail heads poking through the bottom of the next board, any higher and your siding is likely to be loose and could even rattle in the wind.

High nails are very common from inexperienced James Hardie installers, because they think the nails can go anywhere above the nail line. Most of the James Hardie installation requirements in Canada are designed to deal with excess moisture. Because we get so much snow and ice in Edmonton, these requirements are very important. During my time working for James Hardie, I very rarely got calls from homeowners that wanted to submit a warranty claim for their Hardie siding.

The majority of the claims that I did see were from people who had their siding installed so it was touching the driveway, or sometimes right down into the dirt of their flower beds! James Hardie siding is made of cement, so it will absorb moisture if it is installed like this.

If Hardie is installed too close to these surfaces, there is a chance that the paint will start to bubble and peel. This happens because the boards are wet almost all the time, and the water in the board will start to expand and contract as the temperature changes. So, go ahead and install your Hardie wherever you like! Just keep in mind that you may be replacing some of the boards in the first row much sooner than you thought.

Always remember to match the caulking to the colour of the siding, never to the colour of the trim. For years Quad caulking by Lepage has been the standard Hardie caulking in the Edmonton market. This means that Hardie contractors are used to overapplying their caulking and letting it shrink over time. Can you use roofing nails for Hardie siding? You can shoot Hardie siding on with air powered nailers or use hand driven roofing nails to attach siding to the home or structure.

The nails can be ringed- shanked or smooth just make sure you are hitting the studs in the wall. Nails drive in too high won't hold as won't nails that are over driven.

Do you caulk Hardie board siding? Hardie no longer recommends the caulking of any joint in their lap siding colorplus or primed. Deterioration of the caulking in the joint has become a maintenance issue for home owners over time. Joint flashing is recommended for all hardie lap siding now. What is blind nailing?

If you've never heard the term blind nailing, you're probably wondering what exactly it means. Blind nailing is setting a nail into the hardwood flooring board at a 45 degree angle, just above the tongue of the board and driven down into the joist or subfloor surface. If you wanted to patch the hole I'd probably just caulk it, but if you wanted it to set up hard, use a stick of jb weld or similar and shove the putty in the hole. Then you can drill a pilot hole in it once it's hard.

Or golf tees, broken off when they bottom out. Electro-galvanized nails are acceptable for use with James Hardie Siding Products, but may exhibit premature corrosion. James Hardie recommends the use of quality, hot-dipped galvanized nails. Can you use a nail gun on hardiplank? Fiberboard cement siding can be hand-nailed, but because it's so much harder and more brittle than wood, you have to predrill holes near any edge. You can save yourself a bunch of time by using a pneumatic coil siding nail gun.

Use 6d or 8d galvanized or stainless siding nails and install a single nail about 1-in. How much do you overlap hardiplank? Can you nail Hardie Backerboard? HardiePlank is a type of lap siding that contains cement fibers, making it extremely durable. Lightweight items, such as a soilless hanging basket weighing less than one pound, can be attached anywhere on the siding. For heavier items, like hanging baskets containing soil and plants, you need to use a stud finder to make sure to attach it to a stud, or the weight will pull the screws out of the Hardie board, dropping your baskets to the ground.

Make baskets lighter by placing a 2- to 3-inch layer of styrofoam in the bottom, reducing the amount of soil needed. Choose lightweight plastic containers instead of heavier pottery. Hang baskets at a height that will complement the plant types in them.